Epson 10+ User Manual
Epson powerlite home 10 projector, Projector parts projector specifications

EPSON PowerLite Home 10 Projector
7/03
EPSON PowerLite Home 10 Projector - 1
Projector Parts
Projector Specifications
General
Type of display
Poly-silicon Thin Film Transistor (TFT)
active matrix with Micro Lens Array
Size of LCD panels
Diagonal: 0.55 inches (14 mm)
Lens
F=1.7 to 2.1 mm, f=13.9 to 21.4 mm
Focus adjustment
Manual
Zoom ratio
Digital 1.1 to 1.54, lens at maximum size
Resolution
854
× 480 pixels (480p native resolution)
Color
reproduction
24 bit, 16.7 million colors
Brightness
1000 ANSI lumens (Dynamic color
mode)
Contrast ratio
700:1 (Theatre Black color mode)
Image size
30 to 300 inches (0.76 to 7.6 m)
Projection distance
Tele: 3.7 to 38 ft (1.1 to 11.6 m)
Wide: 2.4 to 25 ft (0.7 to 7.6 m)
Projection methods Front, rear, upside-down (shelf or ceiling
mount)
Sound output
1W monaural
Optical aspect ratio 16.9
Keystone correction
angle
±
15° vertical
Keystone correction
ratio
9.6:1
Noise level
29 dB (Theatre Black color mode)
32 dB (all other color modes)
Supported video
interface standards
HDTV, NTSC, NTSC4.43, PAL,
M-PAL, N-PAL, PAL60, SECAM
Projection Lamp
Type
UHE (Ultra High Efficiency)
Power consumption 132W
Lamp life
About 3000 hours (Theatre Black
color mode)
About 2000 hours (other color modes)
Part number
V13H010L2H
Remote Control
Range
20 feet (6 meters)
Battery
Lithium (CR2025)
Control panel
Infrared
receiver
Ventilation slots
Lens
Adjustable foot
Focus lever
Zoom lever
Remote
control
holder
Audio ports
RS-232 port
Security lock
Power
inlet
S-video
port
Video port
(composite
video)
Input B
(computer)
Input A
(component
video)
Infrared
receiver
Speaker
Lamp cover
Air filter intake vent
Ceiling mount holders
Rubber foot
Adjustable feet
Document Outline
- Projector Parts
- Projector Specifications
- Positioning the Projector
- Turning the Projector On and Off
- Adjusting the Image
- Adjusting the Volume
- Turning Off the Picture and Sound
- Freezing the Action
- Switching Between Picture Sources
- Projector Status Lights
- Troubleshooting
- You see a blank screen or a No Signal message
- The remote control doesn’t work
- Only part of the picture is displayed, or the picture is distorted.
- The picture is upside-down or reversed.
- The picture is blurry
- The colors on the screen don’t look right
- The picture contains static or noise.
- The projector and notebook don’t display the same image
- Using the Remote Control
- Using the Menus
- Replacing the Remote Control Battery
- Cleaning the Air Filter
- Replacing the Air Filter
- Replacing the Lamp
- Transporting the Projector
- Storing the Projector
- Optional Accessories
- Related Documentation