Electrolux Built-in High Speed Oven TINSEB425MRRO - Manual (Page 6)

6
Unpacking & Installation Instruction
UNPACKING AND EXAMING YOUR
OVEN
1. Remove all packing materials from inside the
oven cavity. Do not remove the Waveguide
Cover, which is located on the right cavity wall.
Read and SAVE this Use and Care Guide and
the High Speed Convection Microwave Oven
Cookbook.
2. Remove the feature sticker, if there is one, from
the outside of the door.
Check the oven for any damage, such as
misaligned or bent door, damaged door seals
and sealing surfaces, broken or loose door
hinges and latches and dents inside the cavity
or on the door. If there is any damage, do not
operate the oven and contact your dealer or
ELECTROLUX AUTHORIZED SERVICER.
CHOOSING A LOCATION FOR YOUR
OVEN
You will use your oven frequently, so plan its
location for ease of use. The oven must be
placed on a countertop which is a minimum of
36 inches from the floor. Allow at least 2 inches
on the sides, top and at the rear of the oven for
air circulation. Be sure to position oven so that
the rear cannot be touched inadvertently.
Your oven can be built into a cabinet or
wall by itself or above the electric wall oven
E30EW75DSS1.
Note for built-in kits:
See sketch 1 for proper location when building
in above the specified wall oven. Carefully
follow the wall oven installation instructions. Be
sure that the clearance of the floor between the
wall oven and the high speed oven is minimum
of 3 inches.
Door hinges
Safety door latches Waveguide cover
Door seals and
sealing surfaces
MIN.
3"
Electric Wall Oven
MIN.
36"
SKETCH 1