Electrolux Built-in High Speed Oven TINSEB425MRRO - Manual (Page 36)

36
Cleaning and Care
EXTERIOR
The outside surface is precoated metal and plastic.
Clean the outside with mild soap and water; rinse
and dry with a soft cloth. Do not use any type of
household or abrasive cleaner.
DOOR
Wipe the window on both sides with a damp cloth
to remove any spills or spatters. Metal parts will
be easier to maintain if wiped frequently with a
damp cloth. Avoid the use of spray and other
harsh cleaners as they may stain, streak or dull
the door surface.
STAINLESS STEEL TRIM
The exterior should be wiped often with a damp
cloth and polished with a soft dry cloth to maintain
its beauty. There are also a variety of products
designed especially for cleaning and shining the
stainless exterior of the oven. We recommend
that the cleaner be applied to a soft cloth and
then carefully used on the stainless exterior rather
than sprayed directly on to it. Follow package
directions carefully.
TOUCH CONTROL PANEL
Wipe the panel with a cloth dampened slightly
with water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close door
and touch
STOP/CLEAR.
INTERIOR - after microwave cooking
Cleaning is easy because no heat is generated to
the interior surfaces; therefore, there is no baking
and setting of spills or spattering. To clean the
interior surfaces, wipe with a soft cloth and warm
water. DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier
soil, use mild soap; rinse thoroughly with hot water.
Do not use any chemical oven cleaners.
You may remove any lingering interior odor by
using the Refresh Cycle on page 34.
INTERIOR - after manual/automatic speed
or convection cooking.
Spatters may occur because of moisture and
grease. Wash immediately after use with hot,
soapy water. Rinse and polish dry. Harder
to remove spatters may occur if oven is not
thoroughly cleaned or if there is long time/high
temperature cooking. Do not use any chemical
oven cleaners.
After cleaning the interior thoroughly, residual
grease may be removed from the interior ducts
and heaters by simply operating the oven with
Refresh Cycle on page 34. Ventilate the room if
necessary.
WAVEGUIDE COVER
The waveguide cover is made from mica so
requires special care. Keep the waveguide cover
clean to assure good oven performance. Carefully
wipe with a damp cloth any food spatters from
the surface of the cover immediately after they
occur. Built-up splashes may overheat and cause
smoke or possibly catch fire. Do not remove the
waveguide cover.
ACCESSORIES
The turntable, turntable support, racks and splash
guard can be removed for easy cleaning. Wash
them in mild, sudsy water; for stubborn stains
use a mild cleanser and a non-abrasive scouring
sponge. They are also dishwasher-proof. Use
upper rack of dishwasher for turntable support.
Foods with high acidity, such as tomatoes or
lemons, may cause the porcelain enamel turntable
and splash guard to discolor. Do not cook highly
acidic foods directly on the turntable; if spills occur,
wipe up immediately.
SPECIAL NOTE FOR TURNTABLE
SUPPORT
After cooking, always clean the turntable support,
especially around the rollers. These must be free
from food splashes and grease. Built-up splashes
or grease may overheat and cause arcing, begin
to smoke or catch fire.
Disconnect the power cord before cleaning or leave the door open to inactivate the oven
during cleaning.