Logitek Electronic Systems Mosaic - Manual (Page 36)

Logitek Mosaic Reference Manual
Page 36
Monitor Module
The monitor module controls all monitoring functions:
G U EST/STUDIO s ection: G U EST/STUDIO s ection: G U EST/STUDIO s ection: G U EST/STUDIO s ection:
TB button: inserts the Talkback Mic (as defined in JetSet/AE Config Surface
Settings) into the Guest/Studio monitor bus
FOL MON: When turned on, the route to GUEST/STUDIO will follow
routing changes to the MONITOR section.
MUTE: mutes the Guest/Studio monitor bus.
To change the route, press on the Guest/Studio knob. The knob will turn
green and the take light will light up. Turn the knob until you see what you
would like to listen to. Press Take to accept. To cancel, press the
Guest/Studio knob again. It will exit the mode and turn blue. If FOLLOW
MONITOR is engaged, changing the route with the knob will turn
FOLLOW MONITOR off.
When the knob is blue, it controls the volume.
SEL1 – SEL4 buttons: when pressed, these will change the route to the
Guest/Studio monitor bus if they were programmed via Command Builder
as described in the previous chapter.
HE ADPHONE HE ADPHONE HE ADPHONE HE ADPHONE section: section: section: section:
MONO: sets the headphones to mono
FOL MON: When turned on, the route to the headphones will follow
routing changes to the MONITOR section.
SPLIT: Sends the bus being monitored to the left and cue to the right.
To change the route, press on the Headphone knob. The knob will turn
green and the take light will light up. Turn the knob until you see what you
would like to listen to. Press Take to accept. To cancel, press the
Headphone knob again. It will exit the mode and turn blue. If FOLLOW