Logitek Electronic Systems Mosaic - Manual (Page 21)

Logitek Mosaic Reference Manual
Page 21
The CommandBuilder manual includes details and examples of Mosaic specific features, such as
Monitor Hotkeys, Softkey Buttons and more. The programming of these features does require a
certain level of familiarity with the system. If you need assistance, please contact Logitek Electronic
Systems or your reseller.
Device & Bus Addressing
Each device (such as a fader input or button panel) requires its own Device Number. Within that
device, each button, lamp and feature has a Bus Number. Together, the Device and Bus Numbers
allow the JetStream and Surface to communicate.
When configuring the Mosaic’s programmable buttons in CommandBuilder, you will require the
Device Number and Bus Number for each button or lamp. The information below will help you
determine the addressing scheme in use on your Mosaic.
Modules Modules Modules Modules
Module How Addressing is determined Max Modules Supported
Mosaic-MON Uses the standard Monitor, Headphones, Guest/Studio & Cue Gain addressing 1
Mosaic-FADER Device Set determined by COM port allocation (pre-defined) 6 modules (24 faders)
Mosaic-METER Uses standard PGM Meter addressing 1
Device Numbers Device Numbers Device Numbers Device Numbers
In Mosaic v1.x the Device Number of a module is determined by its firmware and position.
Wide Softkey Addressing
The twelve softkeys at the top of the wide softkey module follow the Numix Bridge Button
addressing scheme, therefore the
Bridge Button and Bridge Lamp keywords in Command
Builder may be used.
The softkey buttons for a console connected to JetStream port 1 are on device 28 and the lamps are
on device 27. For port 2, use device 50 for buttons and 4F for lamps. For port 3, use device 64 for
buttons and 63 for lamps. Bus numbers are 32-43.