2 802.3x function setting jp2, 3 fx duplex setting jp3, 2 jp1-jp3 factory default settings – Linkskey LKS-MC110ST User Manual
Page 19
-19-
3.1.2 802.3x Function Setting JP2
IEEE 802.3x function is the flow control method used for full duplex op-
eration on TP port and FX port under store and forward mode. This
method uses pause frames for one port to stop further transmission from
its link partner.
3.1.3 FX Duplex Setting JP3
This setting is used to set the duplex mode of the FX port.
3.2 JP1-JP3 Factory Default Settings
The factory default settings for JP1, JP2, and JP3 are as follows:
JP1
Open Store-and-forward mode
JP2
Open 802.3x function is enabled
JP3
Open FX port full duplex
This manual is related to the following products: