Bang & Olufsen BeoSystem 3 Getting Started - No ATSC - Manual (Page 5)

Contents
Daily use
6 How to use your remote control
8 Introduction
10 Watch television
12 Watch 3D television
14 Change sound type and picture format
15 Use the Adaptive Sound Technology
Installation and setting up
18 Set up your television
19 Cleaning
20 Connection panels
22 First-time setup of your television
Cautions
– Ensure that the television is positioned, set up
and connected in accordance with the
instructions in this Getting Started. To prevent
injury, use Bang & Olufsen approved stands and
wall brackets only!
– Place your television on a firm, stable surface.
– Do not place any items on top of your television.
– Do not subject the television to rain, high
humidity or sources of heat.
– The television is intended for indoor use in dry,
domestic environments only. Use within a
temperature range of 50–95°F (10–35°C), and
at an altitude of no more than 5,000 ft (1,500 m).
– Do not place the television in direct sunlight or
direct artificial light, such as a spotlight, as this
may reduce the sensitivity of the remote control
receiver. Also if the screen is overheated, black
spots may appear in the picture. These spots
disappear again, once the television cools down
to normal temperature.
– Leave enough space around the television for
adequate ventilation.
– Connect all cables before connecting or
reconnecting any of the products in your system
to the mains.
– No naked flame sources, such as lighted candles
should be placed on the apparatus.
– To prevent the spread of fire, keep candles or
other open flames away from this product at all
times.
– Do not attempt to open the television. Leave
such operations to qualified service personnel.
– Do not strike the glass with hard or pointed items.
– The television can only be switched off completely
by disconnecting it from the wall socket.
– The disconnect device shall remain readily
operable.
– The supplied plug and mains cord are specially
designed for the product. Do not change the
plug and if the mains cord is damaged, you
must buy a new one from your Bang & Olufsen
retailer.