Bang & Olufsen BeoSystem 3 Getting Started - No ATSC - Manual (Page 23)

In
st
al
la
tio
n a
nd
s
et
ting
up
2 *Navigation button
Projector
If you have a Beo4 without navigation button or if your Beo4 is not set to the
correct mode, you cannot enable the navigation button. See the Beo4 guide
or contact your Bang & Olufsen retailer for further information.
If you have connected a projector and not a screen, you must switch off the
television after first-time setup and then switch it on again for your settings to
take effect. NOTE! For further information about remote
controls and first-time setup, see the Guide.
First-time setup of loudspeakers
applies only to speakers for TV viewing.
See the Guide for further information.
Adjust volume, bass, treble and
loudness and preset two default
speaker combinations.
Calibrate the speakers
Set up the speakers to optimise sound from your
listening position. To enjoy Adaptive Sound
Technology several speakers and a Beo6 remote
control are necessary.
Disable or enable Adaptive Sound Technology
Make settings for each LISTENING
PRESET. See the Guide for further
information.
Make standby settings for the TV
Make standby settings
Set the TV to switch itself to standby after some
time with no operation.
See the Guide for further
information.
AST ON:
SPEAKER SETUP
TV LISTENING PRESET
CINEMA LISTENING PRESET
SOUND ADJUSTMENT
SOUND SETUP
AST ON/OFF
AST OFF:
SPEAKER TYPES
SPEAKER ROLES
SPEAKER DISTANCE
SPEAKER LEVEL
SOUND ADJUSTMENT
AUTO STANDBY
23