Bang & Olufsen BeoSystem 3 Getting Started - No ATSC - Manual (Page 18)

Set up your television
Follow the guidelines for placement and connection described on this and the
following pages.
Important
Run cables
When you connect external equipment to the
system, we recommend that you connect
equipment to the sockets at the far ends of the
socket panel first, and work your way in towards
the middle of the socket panel. This allows you
access to the necessary sockets throughout the
connection procedure.
1 Mount the left and right cable bracket on the
system as shown.
2 Open the cable brackets, make the necessary
connections, run the cables down through the
brackets, and close the brackets.
3 When connections are complete, attach the
cable cover by sliding the cable cover down over
the cable brackets. The tabs (A) should fit the
gaps in the cable cover.
4 Press the cable cover down lightly until it clicks
into place. To remove the cable cover, press the
tabs (A) inward with your thumbs while lifting
the cable cover with your fingers.
To ensure proper ventilation, allow for at least 2” (5 cm) of space on each side
of the TV and 4” (10 cm) above it. Do not cover the ventilation holes on the
rear. At overheating (flashing standby indicator and an on-screen warning),
switch the TV to standby, not off, in order for the TV to cool down. You cannot
operate the TV during this time.
Ventilation NOTE! Do not allow still pictures, such as logos,
video games, computer images, and images
displayed in 4:3 format, to be displayed on the
screen for an extended period of time. This can
cause a permanent after-image to remain on the
screen.
A A
click click
18
1 2
3 4