Bang & Olufsen BeoPlay V1 Getting Started - Manual (Page 8)

Connection panel – BeoPlay V1–32
Important
Any equipment you connect to the connection panel must be registered in the
SOURCE LIST SETUP menu.
Mains cord and plug Connect the ~ socket on the connection panel of your TV to the wall outlet.
The TV is in standby mode and ready to be used.
The supplied plug and mains cord are specially designed for the product. Do
not change the plug and if the mains cord is damaged, you must buy a
Bang & Olufsen approved mains cord.
1 *Make sure the cable connection between the
product and the router does not exit the building
to avoid contact with high voltage.
Ethernet ( )* 1
For connection to the Internet.
For software updates or for
UPnP streaming of digital photos,
video or music files from, for
example, a NAS device
SATELLITE (14/18V – 0.4A)
Aerial input socket for a digital satellite signal.
Depending on your tuner options, you may have
either one or no satellite socket. Never connect an
optional active antenna here
2 x COMMON INTERFACE (CA Module)
For insertion of a CA module and smart card
for access to coded digital channels. For more
information about compatible smart card and
CA module combinations, contact your
retailer. See the online guide for information
on correct insertion*
2
USB ( , 5V – 0.5A)
For connection of a
USB device to browse
digital photos, video or
music files
AERIAL (5V – 50mA)
Aerial input socket for an
external aerial/cable TV network
or for an analogue signal
~ – Mains supply
Connection to the
mains supply
ANTENNA WLAN
For connection of wireless
network antenna (optional)
WLAN
ANTENNA
AERIAL COMMON INTERFACE SATELLITE
CHIPSIDE
CHIPSIDE
5V 50mA
8