Bang & Olufsen BeoVision 11 with Beo4 User Guide - Manual (Page 11)

11
During setup of a source via the SOURCE
LIST SETUP menu, you can select how a
PUC controlled product is connected.
You can choose between PLUG (cable)
and IR BLASTER (IR-transmitter). If you
select PLUG, you must choose between
MODULATION ON and MODULATION
OFF. For information about type of cable
and modulation settings, contact your
Bang & Olufsen retailer.
IR-transmitters: To operate non-Bang &
Olufsen products with a Beo4/Beo6 remote
control, attach a Bang & Olufsen IR-
transmitter on your non-Bang & Olufsen
product and then connect it to one of the
sockets marked PUC on the connection
panel. Attach the transmitter near the IR-
receiver on the connected equipment to
ensure remote control operation. Before
attaching it, check that you can operate the
equipment menus on the television screen
using the Beo4/Beo6 remote control.
For an extra PUC cable, contact your Bang &
Olufsen retailer.
For information about download of
Peripheral Unit Controller (PUC) tables for
set-top boxes,
see page 48 .
>> Connections
If you want to watch coded channels,
contact your service provider. The
service provider will register you as an
authorised viewer, usually requiring
payment. You will then be provided
with a Smart Card and a CA Module.
Note that these will only be valid for
one service provider and therefore only
work with certain channels.
The CA module is a ‘card reader’ for your
Smart Card which decodes the coded
signals sent out by the service provider.
Only uncoded digital channels, also
known as ‘free-to-air’ channels, are
available without Smart Cards and CA
Modules.
Contact your Bang & Olufsen retailer for
information about compatible CA Modules.
The Smart Cards must remain in the CA
Modules, unless your service provider asks
you to remove it. This is important in case
your service provider wishes to send new
information to your Smart Card.
Insert a Smart Card carefully into a CA
Module. The CA Module has one protruding
edge on one side and two protruding edges
on the other side. If the television does not
receive any signal, check that the Smart Card
and CA Modules are inserted correctly.
Smart Cards and CA Modules may also give
access to special menus which are not
described here. If this is the case, follow the
instructions from your service provider.
Digital channels
Control
STB
STB
PLUG
IR
COMMON INTERFACE
CHIPSIDE
CHIPSIDE
Continues …