Bang & Olufsen BeoVision 11 with Beo4 User Guide - Manual (Page 10)

10
>> Connections
Connect speakers to the television
You can connect up to ten wired speakers
and subwoofers to the television. In
addition, you can connect up to eight
speakers wirelessly, including subwoofers,
if your television is equipped with a
wireless Power Link module. For more
information about setting up wireless
speakers,
see page 20 .
Disconnect all systems from the mains
before you connect additional equipment.
Depending on the type of equipment you
connect to the television, different cables
and maybe also adaptors are needed. Cables
and adaptors are available from your Bang &
Olufsen retailer.
Connect speakers
> Connect a Power Link cable to the
appropriate socket on the speakers you
wish to connect to the television.*
1
> Run the cables to available sockets marked
PL 1–5 on the television.
> Run a Power Link cable between the
appropriate sockets on additional speakers,
if available.
> Connect a Power Link cable to the
appropriate sockets on a subwoofer.
> Run the cable to an available socket
marked PL 1–5 on the television.
> Reconnect the television and the
connected equipment to the mains.
1 *Remember to set the switch for left and
right position on the speakers.
To connect two speakers to one PL socket, a
special cable is needed. If it is not possible to
loop the cable between two speakers, an
extra splitter is needed, contact your Bang &
Olufsen retailer for more information.
PL 5 PL 4
PL 3 PL 2 PL1
Example of a speaker setup.
Rear speaker Rear speaker Subwoofer
Front speaker Front speaker