LeMond RevMaster Pro - Manual (Page 26)

Pg. 24
RevMaster Service Manual
brAke Assembly
Use an adjustable crescent wrench to remove/install brake assembly .
Removal
Turn the brake rod counterclockwise to loosen the tension . Loosen the brake frame nut with a crescent
wrench . Make sure the two flat edges of the plastic nut on the very bottom of the rod are facing the
front and rear of the bike . The flat surface of the plastic nut will then line up with the flat surface inside
the tube . Pull up on the brake assembly and remove from the frame .
Installation
Check that the brake rod nut located between the two springs is threaded on the lower portion of the
top set of threads . Line up the flat surface of the brake rod nut with the flat surface of the plastic nut on
the bottom of the brake rod . Insert the brake rod assembly into the frame with the flat surfaces of both
nuts facing the back of the bike so they meet the flat surface inside the tube . Tighten down the brake
frame nut .