LeMond RevMaster Pro - Manual (Page 17)

Pg. 15
ASSEMbLY/DISASSEMbLY/ADjUSTMENT
hAndlebAr
When the handlebar is first installed on the bike there is a slider plunger (or “pill”) at the end of the ad-
justment handle that is held in place by shipping material . The material is pushed out of the way when
the handlebar assembly is slid onto the track of the handlebar post . The adjustment handle pushes the
slider plunger against the track to secure the handlebar assembly in place .
Installation
Loosen the adjustment handle on the handlebar assembly . Slide the assembly onto the track of the
handlebar post and tighten the adjustment handle . Then install the handlebar track cap onto the end of
the track with two (2) M4 X 10mm screws .
Removal
To remove the handlebar assembly, first remove the track end cap . Loosen the adjustment handle and
slide the handlebar off the end of the track . Take care not to dislodge the slider plunger at the end of the
adjustment handle .