LeMond RevMaster Pro - Manual (Page 19)

Pg. 17
crAnk Arms
Use a 8mm hex wrench to install/remove crank bolts & use a Park CCP-2 or similar crank arm puller to
remove crank arms .
removAl
Left crank - Unscrew the crank bolt with 8mm hex wrench . Thread crank puller into the threads of crank
arm being careful not to cross the threads and tighten by hand . Turn the handle of crank puller clock-
wise until crank arm is removed .
Right crank - Remove the belt cover and drive belt . Unscrew the crank bolt with 8mm hex wrench and
follow same directions as Left crank .
Installation
Lubricate the taper of the spindle with a small amount of multi-purpose grease . Slide the crank arms
onto the spindle assuring they are rotated 180 degrees from each other . Screw in crank bolts (new
bolts are factory coated with Loctite or if needed use medium 242 strength Loctite) and firmly tighten .
Recheck periodically .