LeMond RevMaster Pro User Manual
Page 15

Pg. 13
TRoUbLE ShooTINg
SYMPToM: Seat or handlebar post move after locked into position.
Locate smaller 3mm hex bolt at pivot point of cam handle and loosen 1 turn .
1 .
Disengage 6mm hex bolt on other side from indicator plate and rotate one notch towards (+) sign .
2 .
Tighten smaller 3mm hex bolt .
3 .
Test post and repeat process if needed until post no longer moves .
4 .
SYMPToM: Clicking noise with each pedal revolution.
Check shoelaces to make sure the aglet is not tapping the bike as the pedals turn .
1 .
Assure pedal straps are tight and that no excess strap on inner part of pedal is catching on the crank
2 .
arm as it turns .
Assure that pedals are tight on crank arms .
3 .
SYMPToM: Clicking noise when flywheel rotates.
Check edge of flywheel that brake pad rubs against for small burrs .
1 .
If burr is present gently remove while being careful not to damage flywheel surface .
2 .
If symptom persists check for noisy flywheel bearings .
3 .
If flywheel bearings are noisy or rough have authorized service technician replace flywheel hub as-
4 .
sembly .
SYMPToM: Drive belt is slipping.
Remove belt cover .
1 .
Note: Use caution around belt when cover is removed.
Loosen idler with 8mm hex and tighten tensioner bolt 2-3 turns with 5mm hex wrench .
2 .
Tighten idler and test belt .
3 .
If belt still slips repeat process until belt no longer slips .
4 .
Reinstall belt cover .
5 .
SYMPToM: knocking noise or play felt in pedals/cranks.
Make sure pedals are tight on crank arms .
1 .
Note: Left pedal is reverse threaded.
Make sure crank bolts are tight . If loose, apply blue Loctite 242 to threads and tighten crank bolts
2 .
with 8mm hex wrench .
If problem persists check the bottom bracket bearing cups for looseness . Tighten if necessary with
3 .
a bottom bracket tool and use blue Loctite 242 on threads .
If knocking noise still persists contact authorized service technician for replacement of bottom
4 .
bracket bearings .