Elektra Beckum TKHS 315 (AUS) - Manual (Page 16)

16
ENGLISH
3. Apply a light coat of Care and Main-
tenance Spray.
4. Install saw blade and tighten arbor
bolt.
5. Install the table insert.
10.3 Saw storage
A
Danger!
Store saw so that
− it can not be started by unauthor-
ized persons, and
− nobody can get injured.
A
Caution!
Do not store saw unprotected
outdoors or in damp environment.
10.4 Maintenance
Before switching ON
Visual check if distance saw blade – riv-
ing knife is 3...8 mm.
Visual check of power cable and power
cable plug for damage; if necessary
have damaged parts replaced by a qual-
ified electrician.
After switching OFF
Check to see if the saw blade post-runs
for more than 10 seconds; if so, have the
electronic motorbrake replaced by a
qualified electrician.
Monthly (if used daily)
Remove saw dust and chips with vac-
uum or brush; apply light coat of oil to
guide elements:
− threaded rod and guide rods of
blade rise and fall mechanismn:
− swivel segments.
Every 300 hours of operation
Check all screwed joints, retighten if
necessary.
A
Danger!
Repairs to electric tools must
be carried out by qualified electri-
cians only!
Electric tools in need of repair can be
sent to the service centre of your coun-
try. Refer to the spare parts list for the
address.
Please attach a description of the fault to
the electric tool.
• Lower saw blade fully.
• Dismount add-on parts (fence, slid-
ing carriage).
• If possible use original carton for
shipping.
For special tasks the following accesso-
ries are available at your specialist
dealer – see back cover for illustrations:
A Universal Wheel Set
For easy moving.
B Sliding Carriage
For convenient guiding of long
stock.
C Table Side Extension, right
Table size 1000 mm x 600 mm;
with foldable supports.
D Suction Adapter
To connect a shop vacuum to the
dust collection attachment.
E Care and Maintenance Spray
To remove resin residue and pre-
serve metal surfaces.
F Saw blade CV 315 x 1.8 x 30
56 multiple combination teeth
for solid wood and particle board.
G Saw blade CV 315 x 1.8 x 30
80 neutral multiple teeth
for especially smooth cuts in solid
wood and particle board.
H Saw blade TCT 315 x 2.8 x 30
48 universal alternate bevel teeth
for all woods and wood-derived
materials.
I Roller Stand RS 420
J Roller Stand RS 420 W
K Roller Stand RS 420 G
11. Repairs
12. Transportation
13. Available accessories