Lanner LEC-2280E-7BN4/8 - Manual (Page 25)

25
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Wall Mounting
The product ships with wall mounting kit. To mount your
product on the wall, follow the instructions below:
First make a hole for the anchor in the surface on the 1.
wall. Use the following diagram as a guideline for
placing the anchors.
Then press the anchor into the hole until it is flush with
2.
the surface. You may need a hammer to tap the wall
anchor.
Use a screwdriver to screw the threaded screw into the
3.
plastic anchor.
Attach the wall mounting bracket to the back of the
4.
device, securing it in place with four of the flat-head
screws provided.
Hang the device on the wall.
5.
Unit: mm
dC IN
– +
Connecting Power
Connect the LEC-2280E-7BN4/8 to a +9~+30V DC-in power
source. The DC power-in connector comes with a 2-pin
terminal block for its Phoenix contact. This power socket
can only accept the power supply with the right pin con-
tact so be cautious when inserting power to the system.