Lanner LEC-2280E-7BN4/8 - Manual (Page 24)

24
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
Take out the hard disk tray and fix the hard disk on 1.
the tray with 4 mounting screws as illustrated in the
following picture.
Plug the Serial-ATA cable to the hard disk.
2.
Place the hard disk back to the system’s chassis and fix 3.
it with the mounting screws.
Connect the Serial-ATA power and data disk cables to
4.
the Serial-ATA power and disk connectors on the main
board respectively.
Note:
The PCIe support the Max. Dimension as 1.
the following illustrated and the Max. Power
consumption reserved for expansion is 25W in
total.
Daughter boards such as COM ports and 2.
low-profile PCIe extension boards can only
be inserted to the mainboards with the same
version. The board version is shown on top of
the boards.
1 2
3
4
PCIe card holder
slot cover screw
4
5
6