Lanner LEC-2280E-7BN4/8 - Manual (Page 23)

23
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Note: To remove the SIM card, slide the card
reader outward to unlock it.
PCIe Riser Card Installation
The system can accommodate one PCIe expansion
module. In order the install the PCIe expansion module, a
low-profile riser card has to be installed first. Follow these
steps to install the riser card:
Fix the riser card on the bracket with 3 screws. 1.
Install the riser card to the system by connecting the 2.
connectors with the system’s PCIEIO1 connector.
Fix the riser card on the board.
3.
Before connecting the PCIe expansion card to the riser, 4.
loose the screw from the front panel to take off the slot
cover. Also, take off the PCIe card holder.
Connect the PCIe expansion card to the riser.
5.
Fix the card holder back to the system. 6.
Wireless Module Installation
Align the wireless module’s cutout with the Mini-PCIe 1.
slot notch.
Insert the wireless module into the connector
2.
diagonally.
Hold down the other end of the wireless module and
3.
tighten it with the screws.
3G SIM Card Installation
Unlink the SIM card reader first by sliding it outward. 1.
Flip the SIM card reader diagonally. 2.
Align the cut corner of the SIM card pointing toward 3.
SIM card reader. Make sure the ICs will be in contact
with the SIM card reader.
Insert the
4. SIM card into the reader and close the tray.
You should feel a click when the SIM card is locked
securely in the SIM card reader.
Lock
Unlock
2
3
2
3
4
2
3
1