Front panel features, Chapter 1, Introduction – Lanner MR-730 User Manual

Page 6

Introduction

Chapter 1

Network Application Platforms

Front Panel Features

F1 F2 System Panel: LCD System Panel with Interactive Keypad

The LCD System Panel can be programmed to display operating status and configuration information. For more details

or sample programming code, refer to the patch file.

F2 Reset Switch

The reset switch can be used to reboot the system without turning off the power.

F3 Power/Status/HDD LED

Power LED (Green):
Green indicates that the system is powered on.
Status LED (Green/amber):
This LED is programmable. You could program it to display the operating status with the behavior like the following:
If the LED is green, it indicates that the system’s operational state is normal. If it is amber, it indicates that the system is

malfunctioning. For sample code, refer to the patch file.
Storage LED (Yellow):
It is an LED indicator for the CompactFlash card and hard disk. If it is flashing, it indicates data access activities.

F4 Console Port

By using suitable rollover cable (also known as console cable), you can connect to a computer terminal for diagnostic or

configuration purpose. Default terminal configuration parameters: 115200 baud, 8 data bits, no parity, 1stop bit, and no
flow control.

F5 USB 2.0 Port

It connects to any USB devices, for example, a flash drive.

F6 Two FastEthernet/Management Port

These two dedicated FastEthernet ports can be configured as the management port of the system and used only for

traffic management. Similar to the Console port, but the Management port accepts only incoming traffic to the system.

The management port is provided by Realtek RTL8201E controller.

F7 4 Gigabit Ethernet Ports with 2 pair Bypass

The four Gigabit Ethernet ports are provided by Broadcom BCM5482S Dual-Port Gb Transceiver through the SGMII

interface. They are capable of LAN bypass (LAN2-LAN3 pair and LAN4-LAN5 pair) with low power, triple speed (10BASE-T,

100BASE-TX, and 1000BASE-T) support and has extremely low EMI emissions.
Speed LED: If the LED is amber, it indicates that the connection speed is 1000Mbps. If the LED is green, it indicates that

the connection speed is 100Mbps. And if it is off, it indicates that the speed is 10Mbps.
Link/ACT LED (green): If the LED is on, it indicates that the port is linked. If it blinks, it indicates there is traffic.

LAN0

LAN1

LAN2

LAN3

LAN4

LAN5