Lanner MR-730 - Manual (Page 10)

7
Hardware Setup
Chapter 2
Network Application Platforms
Installing the System Memory
The motherboard supports DDR2 memory that features
data transfer rates of 533/667/800 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications. It comes with two Double Data
Rate(DDR2) Dual Inline Memory Modules (DIMM)
Open the DIMM slot latches. 1.
Install the DIMM. 2.
Note:
All DIMMs installed must have the same 1.
SDRAM standard (DDR2 533/667/800 MHz, ECC
Registered). Do not install DIMMs supporting
different speeds.
For DDR2 533/667 MHz memory, the 2.
motherboard can support a maximum of 4 GB in
total.
For DDR2 800 MHz memory, the motherboard 3.
can support up to a maximum 2 GB in total.
1
2 1
Installing the Hard Disk
The system can accommodate two 2.5” Serial-ATA disks.
Follow these steps to install a hard disk into the MR-730:
Unscrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the holes
2.
of the hard disk with the mounting holes of the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA power and drive cables to the
4.
hard disk’s power and drive connectors respectively.
Plug the Serial-ATA drive cable to the Serial-ATA
5.
Connector on the main board.
Plug the Serial-ATA power cable to the Serial-ATA
6.
Power Connector on the main board.
Repeat steps 2 to 6 for installing a second disk if there
7.
is one.
Put the hard disk tray with the installed hard disk back
8.
and fasten it to the system with the mounting screws.
1
2
3
4
6
5
8