Lanner AV-ICE02 - Manual (Page 16)

Software User Manual Version 1.0.1
13
0 Exit Exit the installation script.
(*) not applicable to the AV-ICE02 and other Lanner Coleto Creek
Acceleration cards and network modules.
3.2.1 Acceleration Software Installation
When you run the installation script, select the Install Acceleration Installation option
to install the Acceleration software. Type the following commands:
1. In the /QAT directory, start the installation script:
#cd /QAT
#./installer.sh
You will be prompted for a directory location to build the package and the Build Output
Directory. Use the default values provided by the installation script.
Note:
1. If Error: Could not open file: /etc/dh895xcc_qa_dev0.conf is shown during the
Accleration installation, it is possible that the configuration files were not copied
from /QAT/quickassist/config due to the way that installer.sh detects the
acceleration device(s) via lspci. Remove the line from /usr/share/hwdata/pci.ids
that contains the string 0435 and rerun the Acceleration installation. Alternatively,
copy the appropriate configurationfiles from/QAT/quickassist/config to /etc and
then restart the service with service qat_service restart.
2. If a failed to start device error is shown during the Acceleration installation,
ensure that the kernel option intel_iommu=off has been configured as specified in
the GRUB configuration file. If this kernel parameter is not specified, acceleration
ervices are only available in a guest operating system (in a virtualized