JBL Synthesis SDP-45 4K - Manual (Page 26)

Basic Operation
JBL SYNTHESIS SDP-45
- 26 -
REMOTE CONTROL COMMAND MATRIX
BUTTON MAIN ZONE ZONE 2
POWER Activates and deactivates standby mode.
When standby mode is activated, pressing the power button deactivates standby mode and
activates the SDP-45, including the sources that were activated during the previous operating
session. The red front panel standby button LED lights to indicate that standby mode is
activated.
Note: Power is still supplied to the SDP-45 when standby mode is activated.
Note: Zone 2 power on defaults to Full Mute.
ON Turns SDP-45 ON. If the SDP-45 is already ON then no action will occur.
TEST Turns on the Internal Pink Noise Test with
AUTO-CYCLE through all the speaker outputs
Press TEST again to turn off Auto-Cycle and
turn on MANUAL advance.
Press TEST to advance to the next speaker
when in MANUAL advance.
Press the < button to stop.
Use the SURR < and SURR > buttons or the
VOL Up and VOL DOWN buttons to increase
or decrease speaker output levels.
No Action
ANLG Toggles 2-Channel Analog Bypass On/Off No Action
SPDIF Toggles Digital (COAX or OPTICAL) On/Off Switched Zone 2 output to the Digital to
Analog Output Main Zone signal. This is
shown as DAC for SRC on the 4 line
status display.
HDMI Toggles HDMI Input On/Off No Action