Ion Science Tiger Select - Manual (Page 14)

TIGER MANUAL Ion Science Ltd
Page 14 of 20
Unrivalled Detection. www.ionscience.com
Calibration
7. Connect the calibration gas to the Probe by pushing the pipe on to the end
of the tube holder.
IMPORTANT: For best results the pipe between the calibration gas and the
instrument should be as short as practically possible.
8. If using a flow regulator; switch the gas on and then press the ENTER key
to start the calibration routine. IMPORTANT: At the end of the test cycle
switch off the calibration gas.
8a. If using a demand regulator just press the ENTER key to start the
calibration routine.
The timer will count down, at the end of the calibration cycle a tick / check ()
will appear.
Press the ENTER key to accept the calibration.