Yaskawa GPD505/P5 - Manual (Page 31)

27
TM.IW.01
Parameter Name Function Range/Scale Comment
Frequency Reference Main frequency reference inside
inverter 0 – max Hz
Output Frequency Inverter output frequency (U-02) 0 – max Hz
Output Current Inverter output amps 0 – 200% Inv Rated Not amps but %
Output Voltage Inverter output voltage 0 – 250 VAC 400 V & 600V reads in
200 V scale only
DC Bus Voltage Inverter DC Bus Voltage 0 – 400 VDC 400 V & 600V reads in
200 V scale only
DI Input byte Status of terminal S1 – S6 (U-
07) 0 - 63 Decimal of bits 0 - 5
Inv Status Byte Inverter status bits (U 08) 0 - 256 Decimal of bits 0 - 7
Elapsed Time (Min) Elapsed time monitor in minutes 0 -65535
PID Feedback Value of PID feedback (U-13) 0 – 60 HZ 60 Hz = 100%
Kwh Monitor Kilowatt hour monitor 0 - 65535
S6 Closed Status of S6 0 - 1 1 = Closed (ON)
S5 Closed Status of S6 0 - 1 1 = Closed (ON)
S4 Closed Status of S6 0 - 1 1 = Closed (ON)
S3 Closed Status of S6 0 - 1 1 = Closed (ON)
S2 Closed Status of S6 0 - 1 1 = Closed (ON)
S1 Closed Status of S6 0 - 1 1 = Closed (ON)
Run bit Status of S6 0 - 1 1 = Closed (ON)
Reverse Run bit Status of S6 0 - 1 1 = Closed (ON)
Inverter Ready Bit Status of S6 0 - 1 1 = Closed (ON)
Inv Fault Bit Inverter Fault Bit 0 –1
MODBUS Write Error MODBUS Parameter Write error 0 -FFFFh Parameter Address
MA –MC Closed Status of MA-MC contact 0 -1
M1-M2 Closed Status of M1-M2 contact 0 -1
Fault and Alarm bits Bit status 0 -1 See program for list
Table 3.15: Monitor parameter selections