Yaskawa Modbus TCP/IP SI-EM3D - Manual (Page 9)

3 Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears
damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name
plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function
properly.
u Option Package Contents
Description Option
Ground
Wire
Screws (M3) LED Label
Installation
Manual
–
NS MS
MANUAL
Quantity 1 1 3 1 1
u Tools Required for Installation
• A Phillips screwdriver (M3 metric or #1, #2 U.S. standard) is required to install the option
and remove drive front covers. Screw sizes vary by drive capacity. Select a screwdriver
appropriate for the drive capacity.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for some drive models)
Note: Tools required to prepare the option cables for wiring are not listed in this manual.
3 Receiving
YASKAWA TOEP YAICOM 18A 1000-Series Option Dual-Port Modbus TCP/IP SI-EM3D Installation Manual 9