Yaskawa 2Y25-0423.pdf - Manual (Page 2)

Rel. 09/15/2000 Page 2 of 13 Doc. No. 02Y00025-0423
1.0 Wiring
Wire the incoming power, motor, accessories and control wiring as specified in the GPD515 Technical Manual
TM4515.
If there is an encoder on the motor that this drive is running, wire that encoder to terminals 1 through 9 according to
the PG-W2 instruction sheet (02Y025-0397).
The master encoder (or pulse reference source) should be wired to terminals 10 thru 16 according to the PG-W2
instruction sheet (02Y025-0397).
NOTE: The +12V supply on the PG-W2 card is capable of only 200mA, be sure not to overload it.
2.0 I/O Definitions
2.1 New Multi-Function Digital Input Settings
For Parameters H1-01 through H1-06.
Addition to Table 5-2 Multi-Function Input Terminal Data Settings (Section 5.32)
(2)
Data Function Description Availability
0 1 2 3
80
Pulse B w/ N.O. Closed = Pulse monitor will output speed feedback
(Terminals 3 thru 8)
Open = Pulse monitor will output master reference
pulses (Terminals 10 thru 15)
X
X
X
X
81
Pulse B w/ N.C. Closed = Pulse monitor will output master reference
pulses (Terminals 10 thru 15)
Open = Pulse monitor will output speed feedback
(Terminals 3 thru 8)
X
X
X
X
(2) GPD515 Technical Manual TM4515.
2.2 New Multi-Function Digital Output Settings
For Parameters F5-01 and F5-02, and H2-01 through H2-03.
None.
2.3 New Multi-Function Analog Input Settings
For Parameters H3-05 and H3-09.
None.
2.4 New Multi-Function Analog Output Settings
For Parameters H4-01 and H4-04.
None.