Yaskawa CM092 - Manual (Page 26)

Browser Interface 2-3
Configuration Web Page
The configuration page contains the standard header and footer along with a method of configuring the EtherNet/IP server and web server
interfaces of the EtherNet/IP Option Card.
Fig 2.2 – Configuration Web Page
‹ Web Server Configuration
The web server configuration allows for the setting of the IP Address, Subnet Mask, Gateway and EtherNet/IP server type. All octets must
contain valid numbers between 0 and 255. The Submit button must be pressed, the accepted page displayed and the drive power cycled
before any changes are effective.
„ Configure Network Parameters.
• IP: A series of four (4) octets separated by "." that determines the interface address for the current EtherNet/IP Option Card.
• SubNet: A series of four (4) octets separated by "." that determines the local area network for the EtherNet/IP Option Card.
• Gateway: A series of four (4) octets separated by "." that determines the IP Address of the gateway server. If a gateway server
is not used, select Do not use default gateway in system. The gateway field must contain a valid IP address whether it is used or
not and must not be blank.
• Address Configuration Mode:
USER: The user enters The IP address via the web interface.
DHCP: The IP Address is set by a DHCP server and not by the user via the web interface.
BootP: The IP Address is set by a BootP server and not by the user via the web interface.
Note: Verify that a DHCP or BootP server determines the network address before selecting either.
• Browser Access Configuration: In order to view the web pages, Enable browser interface must be selected.