Yaskawa 1000 Series Drive Option - Manual (Page 14)

5 Installation and Uninstallation Procedure
14 YASKAWA ELECTRIC TOBP C730600 55D 1000-Series Option PS-A10 Installation Manual
◆
Prior to Installing the Option
Prior to installing the option, wire the unit, make the necessary connections to the unit
terminals, and verify that the unit functions normally without the option installed. Refer to
the manual packaged with the unit for information on wiring and connecting the unit.
■ Single Unit Installation
Figure 4 shows the installation distance required to maintain sufficient space for airflow and
wiring.
Figure 4
Figure 4 Correct Installation Spacing
Note: IP20/NEMA Type 1 Enclosure and IP00/Open-Chassis models require the same amount of space
above and below the unit for installation.
Properly connect all pins and connectors.
Failure to comply may prevent proper operation and possibly damage equipment.
Check wiring to ensure that all connections are correct after installing the option
and connecting any other devices.
Failure to comply may result in damage to the option.
A – 120 mm minimum B – 30 mm minimum
NOTICE
B
A
A
B
Top/Bottom Clearance Side Clearance