SMA WINDY BOY - Manual (Page 12)

Settings SMA Solar Technology AG
12 WBSetup-BEN100411 User Manual
5 Settings
5.1 Taking over the inverter factory settings
In order to fit the power curve of an inverter to the wind turbine system optimally, you have to enter
the parameters of the inverter in the "Parameter" value range. You have the possibility of entering the
factory installed parameters and the coefficients (Wind_a
0
- Wind_a
3
) of an inverter type
automatically from the software. You can adjust the coefficients to your wind turbine system more
exactly once they have been taken over.
In order to take over the factory settings of your inverter type, proceed as follows:
1. Select [Device selection].
☑ The selection window opens.
2. Select the inverter type in the "Device type" field, whose power curve is to be adjusted.
3. Select [OK].
☑ The factory settings and coefficients are loaded and displayed in the "Parameters" value range.
5.2 Entering the inverter parameters
If the factory installed parameters of an inverter have been changed, you must manually enter the
adjusted parameters in the "Parameters" value range. Allocate the respective value for every
parameter.