SMA BLUETOOTH REPEATER - Manual (Page 21)

SMA Solar Technology AG Decommissioning
Installation Manual BTREPIN-IA-IEN100211 21
9.2 Detaching the SMA Bluetooth Repeater from the top-hat rail
1. Disconnect the SMA Bluetooth Repeater from the power supply.
• If the SMA Bluetooth Repeater is connected to the plug-in power supply, pull the mains plug from
the socket-outlet and remove the plug-in power supply plug from the SMA Bluetooth Repeater.
• If the SMA Bluetooth Repeater is connected to the Power Modul, disconnect and open the
inverter with installed Power Modul (see inverter installation manual) and remove the
2-pole plug from the "Power 12V" terminal on the SMA Bluetooth Repeater.
2. Push the SMA Bluetooth Repeater downwards
and use a screwdriver to press it against the
bracket. Pull the bracket downwards and remove.
3. Tilt the lower edge of the SMA Bluetooth Repeater
forwards.
4. Remove the SMA Bluetooth Repeater upwards
from the top-hat rail.
5. If the SMA Bluetooth Repeater was connected to the Power Modul, remove the cable
connection from the Power Modul (see Power Modul manual).
9.3 Disposing of the SMA Bluetooth Repeater
• Observe the disposal regulations for electronic waste that apply at the installation site when
disposing of the SMA Bluetooth Repeater.
• To have SMA Solar Technology AG dispose of the SMA Bluetooth Repeater:
– Use packaging which adequately protects the device from damage during transport.
Hint: If available, use the original packaging.
– Send the SMA Bluetooth Repeater back to SMA Solar Technology AG at your own cost with
the information "ZUR ENTSORGUNG" ("FOR DISPOSAL").