Installation – Enviro EF4 User Manual

Page 23

��

��
��
��

��

4. Connect a tee or 90° degree elbow to the

exhaust pipe.

5. This fireplace insert must be installed

with a continuous chimney liner of 3” or

4” diameter extending from the fireplace

insert to the top of the chimney. The liner

must conform to type 3 requirements of

CAN/ULC S635.

6. (Recommended) Install fresh air intake

either through the back of the fireplace or

through the positive flue connector.

When installing the insert into a masonry

fireplace, DO NOT remove any bricks or

masonry, with the following exception:

masonry or steel, including the damper

plate, may be removed from the smoke shelf

and adjacent damper frame, if necessary, to

accommodate a chimney liner. Do this only if

their removal will not weaken the structure

of the fireplace and chimney, and will not

reduce protection for combustible materials

to less than that required by the national

building code.
When installing the fireplace insert into a

zero clearance fireplace, DO NOT cut or

modify any factory firebox parts. If the

fireplace insert does not fit into a zero

clearance fireplace, we recommend you use

an ENVIRO freestanding model and install

as a hearth mounted unit. Install a 3” (76

mm) flex pipe from the stove to the top of

the chimney (see “H

EARTH

OUNT

NSTALLATION

- F

REESTANDING

:”).

When installing the control panel into the surround panel, the

surround does not need to be assembled. The control board will

be found in behind the firebox.

Place the control panel on the backside of the right surround

panel so the hinge is on the outside and the top and bottom

holes on the control panel line up with those on the surround.

Attach using two (2) T-20 screws through the front of the

surround into the circuit board control panel.

After the surround has been assembled and is ready to be

installed on the unit, plug the wiring harness into the control

panel (see Figure 28).

NSTALLATION

ONTROL

ANEL

NSERT

URROUND

ANELS

Installation

Figure 27: Masonry fireplace installation.

Figure 28: Control Panel

Back.

Figure 29: Control

Panel Cover.