Enviro EF4 - Manual (Page 11)

11
Installation
D
ECIDING
W
HERE TO
L
OCATE YOUR
P
ELLET
A
PPLIANCE
:
1. Check clearances to combustibles.
2. Do not obtain combustion air from an attic, garage or any unventilated
space. Combustion air may be obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect
it to an existing masonry or metal chimney (must be lined if the chimney
is over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional
area). An interior vent can be used with approved pipe passing through the
ceiling and roof.
5. Locate the stove in a large and open room that is centrally located in the
house. This will optimize heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded
extension cord to reach the nearest electrical outlet.
R
EMOVING
P
ELLET
S
TOVE
F
ROM
P
ALLET
:
To remove your new stove from its pallet, open the left and right side panels. There are two (2) wood
screws that are holding the bottom of the stove to the pallet. Remove the screws. Close the side panels.
See “P
EDESTAL
I
NSTALLATION
- F
REESTANDING
” or “P
EDESTAL
I
NSTALLATION
- I
NSERT
” to install the pedestal.
Figure 1: Screws to take out to remove stove from pallet.
������
����� ����
������ ����� ������������ �����