SMA BLUETOOTH PIGGY-BACK PLUS - Manual (Page 14)

7 Mounting SMA Solar Technology AG
14 BTPB-Ant-IEN111510 Installation Guide
1. Disconnect and open the inverter (see inverter installation guide).
2. If another communication interface is installed on the interface socket, remove the installed
communication interface (see communication interface manual).
3. Pass the cable tie through the mounting holes of the
display assembly. Make sure to pass the cable tie
below the display assembly.
Item Inverter
*
* "From [...] to [...]" refers to the list of supported inverters, see section 2.1.
A From SB 1100 to SB 3000-KR as well as WB 1100 to WB 3000-IT, referred to as
"Enclosure type A" in the following.
B From SB 3300 to SB 5000TL HC-IT as well as from WB 3300 to WB 3800-IT,
referred to as "Enclosure type B" in the following.
C SB 700 as well as SB 1100, SB 1100E, SB1100LV, SB1100‑IT, WB 1100,
WB 1100E, WB 1100LV with the enclosure type of a SB 700, referred to as
"Enclosure type C" in the following.
D From SMC 4600A to SMC 11000TLRP-10 as well as WB 5000A and
WB 6000A, referred to as "Enclosure type D" in the following.
Risk of lethal electric shock when opening the inverter.
Death or serious injuries.
• Disconnect the inverter on the AC and DC side (see inverter installation guide).
Electrostatic discharge can damage the inverter.
• Ground yourself before touching components by touching the protective conductor (PE) or a
non-coated part of the inverter enclosure.