SMA FANKIT01-10 - Manual (Page 19)

SMA Solar Technology AG 7 Disassembling
Installation Manual FANKIT01-IA-en-12 19
7. If the terminals are assigned, remove the connection cable from the inverter:
• Flip up the terminals and pull out the insulated
wires. Hint: Note down the order of the
connected insulated wires to make it easier to
reconnect them.
• Remove the connection cable from the inverter through the cable gland. Unscrew the swivel
nut to do so.
• Insert the sealing plug in the right-hand cable gland and screw the swivel nut hand-tight onto
the cable gland (see Section 6 "Connecting the Fan Retrofit Kit", page 15).
8. Loosen the cable gland of the fan cable. To do this,
loosen the inner counter nut.
9. Remove the fan cable with the cable gland and nut from the inverter.
10. Loosen the screw on the controller assembly using
an Allen key AF 3.
11. Remove the controller assembly from the inverter.