SMA FANKIT01-10 - Manual (Page 14)

5 Installation SMA Solar Technology AG
14 FANKIT01-IA-en-12 Installation Manual
5.3 Installing the Fan Retrofit Kit in the Inverter
Requirements:
☐ The inverter must be disconnected from the power supply and the lower enclosure lid must be
opened (see inverter installation manual).
☐ The multi-function relay must be removed and the display flipped up (see Section 5.2 "Removing
the Multifunction Relay", page 12).
1. Place the controller assembly in the inverter and
push the ribbon cable upwards behind the display.
The key of the controller assembly must fit into the
cut-out of the display retainer.
2. Fasten the screw of the controller assembly with an
Allen key AF 3.
3. Remove the cover of the enclosure opening for fan enclosures.
4. Insert the fan with fan enclosure in the enclosure
opening. The arrow on the fan enclosure must face
the display.
5. Route the locking tabs on the right-hand side of the fan enclosure underneath the enclosure wall
and press the fan with fan enclosure in the enclosure opening.
☑ The left-hand locking tabs lock into place.