ShoreLand'r BJVBLW - Manual (Page 7)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M307235
Page 7
SPRINGS
The springs are shipped already installed to the axle.
It is ready to install to the frame.
AXLE
Place one of the spring bracket bushings into the rear
of the spring bracket and secure with a 9/16” x 3 1/4”
hex bolt and hex lock nut. Repeat in other spring
bracket.
Position the axle under the frame, then hook the hook
loop of the spring around the bushings just installed.
Note that if the axle is positioned too low when trying to
hook, the hooks will not hook around the bushings.
Raise the front of the springs up so they align with the
front hole of the spring bracket. Secure in place with
9/16” x 3-1/4” hex bolts and lock nuts.
Tighten all spring bolts at this time.
DRUM BRAKE INSTALLATION
Cut the tape securing the brake line hose to the axle.
Place the end of the hose up through the hole provided
in the brake line clip bracket. Secure in place with the
hose clip provided.
Remove the plastic cap from the end of the frame brake
line coming out of the side frame by the axle. Carefully
uncoil the brake line so that it will reach the end of the
hose just attached to the brake line clip bracket. Thread
the brake line fitting into the brake line hose. Tighten.
All bleeding to the line can be done through the bleeder
on the right wheel cylinder.
Fill the actuator reservoir with brake fluid and bleed the
line per the instructions in the brake manual. Note that
the axle is already bled at the factory during assembly.
All bleeding to the line can be done through the bleeder
on the right wheel cylinder. For bleeding instructions
see the ShoreLand’r Owners Manual.