Extron Electronics MPX Plus 866 A Rev. A - Manual (Page 8)

2-2
Refer also to the MPX Plus 866 A User’s Manual at www.extron.com. Refer also to the MPX Plus 866 A User’s Manual at www.extron.com.
Rear Panel
COMPUTER INPUTS VIDEO OUTPUT
O U
T P
U T S
O U
T P
U T S
1 2 3
6 4 5
I
N P
U T
S
1 2 3 4 5
10
7
11 8 9
6
13 12 14 RESET
PHANTOM +48V
15 16
17 18
LAN
ACT LINK
9
10
11
C
12
Y/VID
C
Y/VID
C C
Y
Y/VID
C
Y/VID
13 14 7
8
9 10 11 12
PASS -THROUGH S-VIDEO S-VIDEO VIDEO VIDEO
VIDEO INPUTS
AUDIO INPUTS
COMPUTER OUTPUTS
15 16
17 18
I N P U T S
RS-232 PRIMARY
RS-232
SECONDARY
Tx Rx
Tx Rx
1 3 5 7
2 4 6 8
1 3 5
2 4 6
MIC/LINE INPUTS N15779
1 2 5 3 7 4 6
11 11
13 14 10 8 9 11 12
C Turn off power to the input and output devices, and
disconnect their power cords.
Computer video group
a
RGB video inputs — Connect the analog computer-video
sources to the Computer Input 1 through Computer Input 8
15-pin HD female connectors.
b
RGB video outputs — Connect RGBHV video displays to the
Computer Output 1 through Computer Output 6 15-pin HD
female connectors.
Low resolution video group
c
Video Input 9 and Video Input 10 (composite video inputs) —
Connect composite video sources to these female BNC
connectors.
N Video Input 9 serves as a timing reference for all other
low resolution video group inputs. If one of the inputs is
synced to a blackburst generator, connect that source to
Input 9.
d
Input 11 through Input 14 —
S-video inputs — Connect an S-video source
to a pair of female BNC connectors. Connect
luma (Y) and chroma (C) as shown at right.
Composite video inputs — Connect a
composite video source to the Video (top)
connector in a pair of female BNC connectors
as shown at right.
e
Composite video outputs (Output 7 and Output 8) —
Connect composite video displays to these female BNC
connectors.
N If the input tied to Output 7 or Output 8 is S-video, the
switcher encodes the input to composite video.
If the tied input is composite video, the switcher passes it
through to the output with no processing.
f
S-video outputs (Output 9 and Output 10) —
Connect S-video displays to these female BNC connectors.
N If the input tied to Output 9 or Output 10 is composite
video, the switcher decodes the input to S-video.
If the tied input is S-video, the switcher passes it through
to the output with no processing.
g
Pass-through outputs
(Output 11 and Output 12) —
Connect S-video or composite video displays
to these female BNC connectors. Connect
S-video Y and C or composite video as shown
at right.
N The switcher passes the tied input to
these outputs with no signal processing; an S-video input
is output as S-video, a composite video input is output as
composite video.
12
Y/VID
S-video Composite
video
C
11
12
Y/VID
S-video Composite
video
C
11
MPX Plus 866 A • Installation
Installation
MPX Plus 866 A • Installation 2-3