ShoreLand'r MC2000-03 V.1 - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M312045
Page 6 of 6
Spare Tire Bracket and Tire Wheel Assembly
See Detail F.
Locate the 3/8” x 3 7/16” x 4 1/8” square U-bolt Part No.
0310090 that fits the tongue of your trailer. Place the U-bolt
up and around the tongue from the bottom side. Locate Item
# 9 spare tire bracket with two (2) holes. Align the holes in the
bracket with the legs of the U-bolt and place on the
U-bolt. Secure in place using 1/2” hex flange lock nuts.
Position the bracket on the tongue so it is located at the
approximate center of where the spare tire will be located
when installed and tighten in position.
Locate Item No. 10 spare tire bracket with three (3) holes.
Place it in position as shown and secure it to the bracket just
installed using two- 3/8” x 1” hex bolts and hex flange lock
nuts. The bottom set of holes in the bracket will raise the
bracket into its highest position and will adapt to the larger
tires. Tighten.
Locate the three- 1/2” x 1-1/2” hex bolts. Place them into the
upper bracket as shown from the bottom side. Secure into
place using 1/2” fine threaded nuts. Tighten. The bracket is
now ready for mounting the spare tire to it.
Place the spare tire onto the bracket by aligning the holes in
the wheel rim with the three bolts just installed. Once aligned
allow the spare tire to rest onto the bracket. Secure the wheel
to the spare tire bracket using the three- 1/2” lug nuts
provided. Tighten.
Jack With Caster Wheel
See Detail D.
Locate the jack with caster wheel. Note that it will fit various
size tongues. Place two- 3/8” x 4” hex bolts into the holes in
the mounting plate as shown in the diagram. Hold the jack up
to the tongue so that the two bolts just installed are resting
on the topside of the tongue. Check to make sure that there
is a set of holes directly under the tongue. If there is, place a
channel mounting bracket onto the two bolts. Secure using
3/8” lock washers and hex nuts.
Place two more 3/8” x 4” hex bolts in the holes located
directly under the tongue running them through the jack
mounting plate and the channel mounting brackets as well.
Secure using 3/8” lock washers and 3/8” hex nuts. Tighten.
Assembly is complete.
Detail A
Detail B
Ramp Latch
Handle Assembly