ShoreLand'r MC2000-03 V.1 - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M312045
Page 3 of 6
MC2000-03 MOTOR CYCLE
TRAILER, V-TWIN
Two people are required to properly
assemble this trailer.
CARE MUST BE TAKEN NOT TO
SCRATCH OR DAMAGE THE SIDE
SHIELD PANELS WHEN REMOVING
THEM FROM THEIR SHIP POSITION AND
INSTALLING THEM ON THE TRAILER.
Carefully remove the banded parts and
hardware bag from the frame bundle.
Sort all the items in the hardware bag
by size.
ASSEMBLY INSTRUCTIONS
Axle Assembly
Place the frame on four sawhorses or
something comparable in height and
strength for the assembly process.
Locate the torsion axle assembly.
Position it under the frame so that the
axle end units that have the spindles
welded to them is pointing towards the
rear of the trailer as shown in Diagram
A. Place a 5/8” flat washer on each of
the four 5/8” x 5-1/2” hex bolts and drop
them in the holes in the side frames as
shown in Detail E on page 4. (See Item
# 9). With a jack, hoist, or two people,
raise the axle assembly up under the
bottom side of the trailer frame. Align
the holes in the axle mounting brackets
with the
5/8” x 5-1/2” bolt just installed. Place on
another 5/8” flat washer and secure with
5/8” hex flange lock nuts. Tighten.
Tire and Wheel Assembly
Mount the tire and wheel assemblies
using the 1/2” fine threaded tapered lug
nuts provided. Tighten to 80-90 ft/lb. of
torque using the rotation pattern as
shown in the ShoreLandr’s Owners
Manual. Re-torque the lug nuts
after 50 miles of driving and then
periodically thereafter.
Tongue Assembly
Locate the tongue wire harness in the
hardware bag and unwind. Locate the
four-prong end of the harness. This end
of the harness will plug into the trunk
harness of the tow vehicle. Place the
other ends of the harness into the hole
in the top of the tongue located just
behind where the coupler is to be
mounted. See Detail D. Route the wire
backward in the tongue approximately
42 inches and then bring the harness
back out of the hole provided in the top
of the tongue at this location. Pull the
wire harness out the this hole
approximately 8 inches at this time
which should be plenty harness to make
the connection with the frame harness
later.
Place the coupler on the end of the