ShoreLand'r BK1000U V.2 - Manual (Page 7)

Run the frame harness wires through
the hole on the to side of the tongue
when the trailer is in it’s normal upright
position. Push the wires to the rear of
the tongue and thread the wires through
the wire hole at the top side of the
tongue in it’s normal upright position.
Place grommets in both wire holes. Slide the wire tube (Ref.#) into the rear
cross channel and through the chassis.
Note theat the two pre-drilled holes on
the wire tube must be inserted in first
as shown. Thread the frame harness
wires just installed in the tongue into the
wire tube. Pull wires out the rear of the
tube so that the plugs are exposed. Insert two (2) 1/8” x 1-1/2” cotter key
(Ref.# ) through the pre-drilled holes
on the wire tube (Ref.# ) as shown.
Separate the legs of the cotter key to
secure.
Install molded grommets over the wires
to secure. Insert the wires in the hole
next to the wire tube. Insert the side marker light wires through
the large pre-drilled hole in the side of
the tongue. Pull out the front of the
tongue. Mount the side marker light to
the tongue in the pre-drilled holes using
#10-16 X 3/4” self-drill screws (Ref.# )
as shown. Connect wires from the side marker light
to the plugs provided on the frame
harness - brown on brown.
Insert a 3/8” X 1-1/4 hex bolt with a 3/8”
flat washer and safety chain through the
lower hole on the front of the tongue.
Secure with a 3/8” flat washer and 3/8”
flange lock nut. Repeat procedure on
opposite side of the tongue. Loosen and
remove the rear hex nut holding the
coupler to the tongue and place the
white ground wire on the bolt threads.
Replace the nut and tighten. Place the taillight into the light channel
with the green/brown wiring and white
grounding wire fed through the wire hole
as shown. Notice that the left taillight has the
yellow and brown wire. Slide the taillight
into the light channel. Install the license
plate bracket over the bolts on the
taillight. Attach to the rear crossmember
and secure with the hardware provided
with the taillight.
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M305235
Page 7