ShoreLand'r 3ATV - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003170
Page 6 REV C 02/20/06
into the end of the channels or else placed in the approximate
position, then rotated into place. The right-hand ramp must
always be installed first.
See Detail D. Align the holes provided in the edge of the
ramp with the holes in the center of the ramp retainer attach-
ment channels as follows: Place one of the ¼” pins with
wire retainer through the aligned holes in the ramp and the
retainer attachment channel positioned 10 ½” from the side
of the frame and secure.
Align the hole in the second ramp retainer attachment channel
with the second hole in the ramp. Note that the U-bolt may
have to be loosened so the ramp retainer can be moved either
direction to align the holes. When aligned, insert a second ¼”
pin with wire retainer. Once the pin is inserted, retighten the
U-bolt loosened to adjust for proper hole spacing. The two
pins will secure the ramps in the transport position.
Repeat this process on the second ramp.
CAUTION:
To prevent damage to your ATV trailer, tighten all fasteners
before towing.
Your ATV trailer is equipped with a totally grounded wire
harness. You must be sure the wire harness plug that comes
from the tow vehicle is grounded to the tow vehicle using the
white grounding wire.
Always secure (tie) your load down before towing.
Check all lights for proper operation before towing.
Check all lug nuts for proper torque before towing.