ShoreLand'r TA1015 - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003264
REV D 05/15/2012 Page 8
8. Test the brake system to see if it is bled properly. If brakes func-
tion properly the bleeding process is complete. If they do not
operate properly, repeat the above steps and test again.
9. Brake fluid levels in the reservoir should be checked occasion-
ally to make sure your brake system never runs out of brake
fluid.
See the Titan BrakeRite Actuator Installation and Instruction Man-
ual for Further Information and Operating Instructions.
In- Cab Controller
Locate the In-cab controller supplied with the kit. Remove the in-
structions and install the unit in the tow vehicle using the instruc-
tions supplied.
Note: In the event that you ever intend to use an OEM Ford &
Chevy in-cab controller, a special adapter has been pre-connected
to the trailer tongue harness in this kit. Plug that adapter directly
into the trailer control module using the matching connector on the
control module. This adapter will assure compatibility with all OEM
and aftermarket in-cab controllers. Be sure to include your OEM
in-cab controller installation and tow vehicle electrical system when
troubleshooting problems.
Always test the brake system at slow speeds each time you start
towing to make sure the brake system is functioning properly.
Should you experience a situation where you do not have brakes
or they are malfunctioning, see your local ShoreLand’r dealer im-
mediately to rectify problems.