ShoreLand'r SLV24LW - Manual (Page 4)

Final Assembly Instructions
Remove the small parts from the frame by cutting the
bands. Remove the bolt bag and sort all nuts and bolts by
size.
Tongue:
Remove the tongue assembly from the frame bundle and
install into the tongue channel and secure with a 1/2” X 4”
hex bolt in the side of the tongue and tongue channel.
Secure with a 1/2” flange lock nut.
Place the tongue cover over the rear of the tongue and
tongue channel and secure with a 1/2” X 1-1/2” hex bolt,
1/2” flat washer and 1/2” hex nut.
Tongue Wires:
Install the tongue wire harness through the top forward
wire hole and exit the rear of the tongue channel on the
frame. Install grommets and plug the tongue wire into the
frame harness by color.
Safety Chain:
Insert a 3/8” X 1-1/4” hex bolt with a 3/8” flat washer and
safety chain through the lower hole on the front of the
tongue. Secure with a 3/8” flat washer and 3/8” flange lock
nut. Repeat the procedure on the opposite side of the
tongue.
Coupler:
Mount the coupler onto the tongue with one (1) 1/2” X 4”
hex bolt into the rear of the couplerand tongue and using
two (2) 1/2” X 1” hex bolts into the two (2) front holes on
the coupler and tongue. Secure with 1/2” flange lock nuts.
Bunks:
Mount and secure the bunk assemblies to the adjustable
bunk brackets with 3/8” X 1” hex bolts and 3/8” flange lock
nuts. Make sure the bunks are positioned so that the bunk
bracket attached to the bunk and the bracket attached to
the frame are mounted together so that you have metal to
metal stops to keep the bunks from pivoting to far. Tighten
as far as possible but still allow the bunks to fully pivot side
to side.
DO NOT OVER TIGHTEN - the bunks must pivot freely
to conform to the boats hull.