ShoreLand'r SLRB46TBBLSP - Manual (Page 7)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003568
Page 7
Tire Size and Carrying Capacity Chart
Tire Size ............................ST185/80R 13-C
GVWR ...............................5920 lb.
Carrying Capacity ............4600 lb.
Axle ...................................Disc Brakes
Refer to the tire side wall for correct tire pressure.
ROCKER ARMS
Locate the rocker arms (Ref. No. 5 of Detail A in Diagram D)
Note that the center bushing has a grease zerk in it.
Position the rocker arms up into the center channel welded in the
center of the tandem spring bracket so that the grease zerk is point-
ing down. Align the holes in the channel with the rocker arm. Se-
cure in place with a 3/4” x 4-1/2” hex bolt and lock nut. Tighten.
Repeat this process on the other rocker arm and spring bracket.
Grease the rocker at this time by applying grease through the zerk
just discussed.
NOTE: The grease zerk is positioned down so that it is ac-
cesible for servicing when needed.
SPRINGS
Position the axles so they are properly aligned with the trailer.
Position the brake axle so that the disc brake calipers are on the
back side of the axle. The brake axle must always be mounted as
the rear axle to give you the best braking possible (See Diagram
D). There is no right and left to the axle without brakes. It can be
mounted either way.
Place the springs on the topside of the spring pads welded to the
axle. (See chassis diagram). Note that