ShoreLand'r SLR46TBS V.2 User Manual

Page 9

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0003471

Page 9

eye to prevent your boat from moving forward in the event of a sud-

den stop. It can be moved up or down by removing the back bolt

that mounts the winch head to the base. When this bolt is removed,

the head can be rotated up or down to reach the desired height re-

quired to ﬁt your boat. Once in this position, align the closest pair of

holes in the brackets and reinsert the bolt just removed. Tighten.

Attach the winch strap and crank winch tight. Attach the bow eye

safety chain into the bow eye of the boat as well. This is just an-

other level of protection to keep your boat and trailer together as

one unit.

Adjustments are now complete. Double check your boat for ﬁt. If the

desired ﬁt has been achieved, tighten all fasteners that may have

either been left loose or have been loosened to do the adjusting.

Note: All nuts and bolts must be tightened before towing. The law

requires that the white ground wire on both the tongue wire harness

and vehicle harness be properly grounded to respective trailer and

vehicle frames.

Recheck all fasteners on the complete trailer to make

sure they are all tight and ready for towing. All fasteners should be

periodically checked before towing.

See your ShoreLand’r Owner’s Guide for further technical infor-

mation regarding your trailer and its components.

�

��

�

��