ShoreLand'r SLR22L V.2 - Manual (Page 8)

Tire Size and Carrying Capacity Chart
Tire Size.............................ST185/80R 13-C
GVWR................................2960 lb.
Carrying Capacity.............2200 lb.
Axle....................................Non-Brake
Refer to the tire side wall for correct tire pressure.
NOTE: Brakes available as optional equipment.
Recommended carrying capacity is based on shipping
weight of the trailer with standard equipment. Adding
optional equipment may decrease the trailer’s carrying
capacity.
Springs
Positions the axle so that it is aligned with the trailer.
Place the springs on the top side of the spring pads welded
to the axle. The hook end of the spring must be mounted to
the rear of the trailer. Place a spring clamp on the top center
of the spring. Place the 1/2” X 6-1/2” U-bolts over the top of
the spring clamp, spring and axle. Place the spring and axle
U-bolt plate onto the ends of the two U-bolts. Secure in
place with 1/2” lock nuts. Tighten.
Axle
Place a spring bracket bushing (Ref.#6) into the rear of the
spring bracket and secure with a 9/16” x 3-1/4” hex bolt and
hex lock nut. Repeat in the other spring bracket. Position
the axle under the frame, hook the hook loop of the spring
around the bushings just installed. Note: If the axle is
positioned too low, the hooks will not hook around the
bushings.
Raise the front of the springs up so they align with the front
hole of the spring bracket. Secure in place with 9/16” X 3-
1/4” hex bolts and lock nuts. Tighten all axle U-bolts and
spring bolts.
Tire& Wheel Assembly
Mount the tire and wheel assemblies using the 1/2” fine
threaded tapered lug nuts provided. Tighten to 85-95 ft./lb.
of torque using the rotation pattern as shown in the
ShoreLandr’s Owners Manual.
Re-torque the lug nuts after 50 miles of driving and then
periodically thereafter.
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0003697
Page 8 of 11 Rev A 4/27/2011