beautypg.com

ShoreLand'r SLR22L V.2 User Manual

Page 4

background image

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028

www.shorelandr.com

0003697

Page

4

of

11

Rev

A

4/27/2011

WIRE HARNESS
Locate the wire harness. Push the two triangular plugs in the hole
on the top of the tongue, then out the rear of the tongue. Place the
wire harness through the hole in the tongue cover plate. (See
Detail A) Secure the tongue cover plate in position with a 1/2” X 1-
1/2” hex bolt and 1/2” lock nut. Tighten. Plug the tongue wire
harness ends into the frame harnesses by matching colors and
ends. Push the extra wire into the rear of the tongue or remove the
grommets in the side frame and place the extra wire in the side
frame. Replace grommets just removed.

Winch Post
Place the winch post assembly on the tongue and secure with
three 3/8” X 4” hex bolts and hex flange lock nuts. Place the nuts
on the bolts but do not tighten because they will have to be
readjusted once the boat is on the trailer
.
Remove the winch handle nut from the shaft. Align the hole in the
winch handle with the flat surfaces on the shaft. Slide in position
and secure with the nut just removed. Tighten.

TONGUE
The tongue comes shipped separate of the frame. Locate and
slide the tongue in the front tongue channel. Line the holes in
the tongue with the holes in the tongue channel. Secure with a
1/2” X 4” hex bolt and 1/2” lock nut in the front cross hole.

Locate the coupler bag. Place the coupler on the end of the
tongue, align holes and secure with one 1/2” X 4” hex bolts and
hex flange lock nuts in the rear coupler hole. Place two 1/2” X 1”
hex bolts into the front holes of the coupler and secure to the
each side of the tongue with 1/2” flange lock nuts. Tighten.

SAFETY CHAINS
Mount the safety chains to the front of the tongue by placing a
3/8” flat washer onto a 3/8” X 1-1/4” hex bolt, then insert the bolt
through the last link of the safety chain. Put the bolt through the
hole on one side of the tongue as shown. Place on another flat
washer and secure with a 3/8” hex flange nut. Tighten. Repeat
on the other chain on the other side of the tongue.

This manual is related to the following products: