ShoreLand'r SLR15A V.2 - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003607
Page 9 Rev B 04/15/2009
Adjustments:
Keel Roller:
Load boat - Make necessary adjustments to center bracket and tighten
nuts, tighten other nuts only enough to allow assembly to pivot freely.
Winch:
Once the boat is positioned on the trailer, adjust the winch post to the
boat, adjust the winch post to the boat. Adjust the bow stop bracket so
that the rubber bow stop is just above the bow eye.
Roller Assembly:
Place your boat on the trailer. Determine the spacing on the roller rack.
It may be necessary to adjust your roller rack either further in or out
from the position you have it assemblies. The boat must be adjusted to
miss any keel or strake which might be on your particular boat.
IMPORTANT: The roller racks should be spaced as far apart as pos-
sible for stability. This in most cases will allow your boat to be as low as
possible on the trailer for better trailering, loading and unloading.
Once the roller racks have been spaced properly for your boat, position
the boat on the trailer with the transom flush with the rear roller rack.